Tooling & Vacuum Bagging Processing

Peel ply
Peel plies are a tightly woven fabric, often nylon, which is placed on top of the wet laminate prior to bagging and curing. The peel ply will stick to the laminate, but will pull away without too much difficulty. Peel ply protects secondary bonding surfaces from contamination after cure and when peeled off leaves a surface suitable for secondary bonding or painting. Note that peel ply will absorb a small amount of resin, and this must be accounted for. Peelply must be heat set and scoured by the manufacturer to remove contaminates and reduce shrinkage.

A100PS
White porous nylon peel ply with red tracer. For use directly against laminates or bond lines. Max cure temp 180°C

• Data Sheet

A100FLOGREEN
Fluorescent green porous nylon peel ply for use directly against laminates or bond lines. Max cure temp 180°C

• Data Sheet

B100
White lightweight porous nylon peel ply for use directly against laminates or bond lines, especially where secondary bonding, painting or finishing is required. Max cure temp 180°C

• Data Sheet

D300
Pink porous medium weight nylon 6.6 peel ply for use directly against laminates and bond lines. Max cure temp 180°C

• Data Sheet

Close Window